Blodgett SC-7E Manuale Utente

1SC-7E and SC-10EELECTRIC CONVECTION STEAMERINSTALLATION – OPERATION – MAINTENANCEBLODGETT OVEN COMPANYwww.blodgett.com44 Lakeside Avenue, Burlington,

103.0 OPERATION (Continued)BEFORE FIRST USEClean the protective oils from all surfaces of the steamer. Use a non-corrosive, greasedissolving commercia

11CONSTANT STEAM FEATURE, (OPTIONAL)A switch has been added to control this feature. It is located below the timer under theheading “COOKING MODE”.TIM

12COOKING HINTSYour steamer efficiently cooks vegetables or other foods for immediate serving. Steamcooking should be carefully time controlled. Keep

134.0 CLEANINGWARNING: DO NOT use cleaning agents that are corrosive.WARNING: Disconnect the power supply to the appliance beforecleaning or servici

14GUIDELINES FOR MAINTAINING STAINLESS STEEL SURFACESThere are three things that can break down stainless steel and allow corrosion todevelop:1) Abras

155.0 MAINTENANCEREMOVAL OF SCALE DEPOSITSWARNING: Read and follow instructions on the CLR bottle. Useplastic or rubber gloves to avoid skin contact.

166.0 TROUBLESHOOTINGPROBLEM POSSIBLE CAUSESCold water flows continuously into drainwhen steamer is OFF.Either or both solenoid valves are notclosing.

177.0 SERVICEADJUSTMENT FOR HIGH ALTITUDE LOCATIONSNOTICE: Contact the factory, the factory representative or local servicecompany to perform maintena

188.0 SERVICE (Continued)WATER OVERFLOWS INTO COOKING COMPARTMENTWhen steamer is first turned on for the day, and the following conditions occur:- RE

2IMPORTANT NOTES FOR INSTALLATION AND OPERATIONThis is the safety alert symbol. It is used to alert you to potential personalinjury hazards. Obey al

3TABLE OF CONTENTS DESCRIPTION PAGE1.0 Service Connections ...

41.0 SERVICE CONNECTIONS

52.0 INSTALLATION INSTRUCTIONSThis steamer was inspected before leaving the factory. The transportation companyassumes full responsibility for safe de

6ELECTRICAL CONNECTIONWARNING: Electrical grounding connections must comply withapplicable portions of the National Electrical code and/or other loca

7DRAIN CONNECTIONSThe drain connection must be 1" (25 mm)IPS down, preferably with one or twoelbows only, maximum length 6 feet (1830mm) and pipe

8VENT HOODSome local codes may require the steamer to be located under an exhaust hood.Information on the construction and installation of ventilating

93.0 OPERATIONWARNING: Live steam and accumulated hot water in thecompartment may be released when the door is opened.WARNING: An obstructed drain c